________________________________________________________________ Message: 2816023, 96 lines Posted: 11:59am EDT, Fri Apr 10/92, imported: 11:59am EDT, Fri Apr 10/92 Subject: RE: KS10 To: John Wilson Cc: tlitt@vino.enet.dec.com From: tlitt%vino.enet.dec.com@enet-gw.pa.dec.com [...] All revisions are Minimum. Typos are possible. RH11-C MASSBUS CONTROLLER, lowest acceptable wire list Revision C M7294-YA DATA BUFFER AND CONTROL lowest etch rev CS Rev* JUMPER DISK TAPE W1 OUT OUT W2 IN IN E66, PINS 1-16 IN IN 5-12 OUT OUT 7-10 OUT OUT 2-15 IN IN 3-14 OUT OUT 4-13 OUT IN 6-11 IN OUT M7295 BUS CONTROL lowest etch CS rev D W1 OUT OUT WE OUT IN W3 OUT OUT W4 IN IN W5 OUT OUT W6 OUT IN W7 OUT IN W8 IN OUT E3, PINS 1-16 OUT IN 2-15 OUT IN 3-14 IN OUT 4-13 IN OUT 5-12 IN OUT 6-11 OUT OUT 7-10 IN OUT 8-9 OUT IN W11 IN IN W12 IN OUT W13 OUT IN W14 IN OUT W15 OUT OUT W16 IN IN W17 OUT OUT W18 OUT OUT W19 IN IN E57 contains BR6 (54-08780) M7296 CSR CS rev B W1 IN IN M7297 -- leds indicate massbus parity error M9300 Rev 0 location AB08 W1 IN W2 OUT W3 OUT Led is config error M5904 CS Rev D M688 (must remain in E14 [...] T ________________________________________________________________ Message: 2865095, 44 lines Imported: 3:57am EDT, Wed May 6/92 Subject: Re: RH11 ECO To: John Wilson From: TERRY@spcvxa.spc.edu > I'd be VERY interested in the RH11 RM ECO, if it wouldn't be too much > trouble to find. Ok, it's at the end of the message. > Do you know if this has anything to do with the RH11C, > the KS10 version of the RH11? No idea, although the M7294 for an RH11 is not the -YA version. Here's the FCO: Rev check: Need M7294 CS K, etch B or C Wire cuts, side 1: E36-13 to E98-10 @ PTH above E37-12/13 Wire cuts, side 2: E98-01 to E91-04 @ PTH near E98-01 Wire adds, side 1: E36-13 -> E66-06 E98-10 -> E66-11 E98-01 -> E66-08 E98-04 -> E66-09 Wire adds, side 2: Other: Remove jumper between E66 pins 02 and 15 Remove following jumpers for 1184 operation, insert for all other CPU: E66 06 - 11 E66 08 - 09 E66 02 - 15 Terry